| 1 | Quality management system | Check whether the manufacturer operates a documented quality management system and whether its scope covers the relevant device and production site. | Current certificate, issuing-body details, scope, site information, and verification through the issuer’s directory where available. ISO 13485 is a medical-device quality management standard; certification alone does not establish product safety or effectiveness. |
| 2 | Regulatory status | Confirm the product’s intended use, classification, target market, and applicable regulatory route. Distinguish device registration or clearance from general company registration. | Device-specific records or certificates that can be checked with the relevant authority. For the EU, verify applicable conformity documentation and CE marking requirements; for the United States, do not treat FDA establishment registration as FDA approval or clearance. |
| 3 | Wavelength specifications | Request the measured emission wavelength or wavelength range for each LED channel, including the measurement method and tolerance. | Model-specific spectral measurement report from a qualified laboratory or documented test setup. Do not rely on color names such as “red” or “blue” as a substitute for measured wavelength data. |
| 4 | Irradiance and dose | Verify irradiance at the stated treatment distance or skin plane, treatment duration, and the resulting radiant exposure (fluence), with units and calculation method shown. | Test report identifying the device configuration, measurement position, instrument, units, and operating conditions. Compare like-for-like measurements; output can vary with distance, angle, and test method. |
| 5 | Output uniformity | Assess how evenly light reaches different treatment areas, including locations near the edges and around the nose, cheeks, and forehead. | Measurement map or test data from multiple positions on a defined facial fixture. Ask how the manufacturer defines and calculates uniformity rather than accepting an unsupported “uniform output” claim. |
| 6 | Photobiological and electrical safety | Check whether optical radiation hazards and electrical safety have been assessed for the finished device and its intended use. | Relevant test reports may reference IEC 62471 for photobiological safety and applicable IEC 60601 standards for medical electrical equipment, where appropriate to the product and market. Confirm the tested model and configuration. |
| 7 | Materials and skin contact | Review the materials that contact the face, including coatings, straps, and adhesives, and how irritation or other biological risks are addressed. | Material declarations and a risk-based biological evaluation. ISO 10993 standards may be relevant to evaluating biological safety of materials in contact with the body; applicability depends on the device and contact conditions. |
| 8 | Thermal and operational controls | Check temperature behavior during the full treatment cycle, timer accuracy, automatic shutoff, and safeguards against unintended operation. | Test records for representative operating conditions, plus inspection of user instructions, fault handling, and control functions. Request details on how overheating and foreseeable misuse are addressed. |
| 9 | Production consistency | Determine how incoming LEDs and other components are checked and how finished-product performance is monitored from batch to batch. | Documented inspection and production test procedures, calibration records, traceability information, and sample batch records. Ask whether wavelength and output are checked on finished units or only on component samples. |
| 10 | Documentation and after-sales support | Evaluate the completeness of instructions, contraindications and warnings, warranty terms, complaint handling, spare parts, and change-control communication. | Current user manual, labeling samples, warranty and service terms, complaint and corrective-action procedures, and written notification process for product or component changes. |