| Architectural window and curtain-wall profile | 6063-T5 or 6063-T6 | Clear, bronze, or black; specify coating thickness and sealing requirements for the intended exposure. | Visible surface quality, dimensional tolerances, structural loads, drainage details, color consistency, and indoor or outdoor exposure. | Window frames, door frames, storefronts, and curtain-wall components. |
| Modular T-slot framing profile | 6063-T5 is common; 6061-T6 may be selected where higher strength is required. | Often clear or black anodized; confirm that the finish does not interfere with slot fit or accessory contact points. | Slot dimensions, load and deflection requirements, connection method, assembly frequency, and compatibility with fasteners and accessories. | Machine guards, workstations, equipment frames, and modular enclosures. |
| Heat-sink profile | 6063-T5 or 6063-T6 | Clear or black anodized, depending on appearance and thermal-radiation requirements. | Thermal resistance, fin spacing, airflow, available extrusion geometry, operating temperature, and electrical-contact requirements. | LED fixtures, power electronics, and other electronic cooling assemblies. |
| Solar mounting profile | 6005A-T6 or 6063-T6, depending on design and load requirements. | Typically clear anodized; coating specification should reflect the installation environment. | Wind and snow loads, span, fastener compatibility, roof or ground-mount conditions, drainage, and exposure to moisture or salt. | Solar-panel rails, supports, and mounting components. |
| Structural or heavy-duty extrusion | 6061-T6 or 6005A-T6 | Clear or colored anodizing where a protective or decorative surface is required. | Design loads, section stiffness, wall thickness, machining needs, connection details, and whether the specified temper is suitable for fabrication. | Equipment supports, structural frames, transport components, and industrial assemblies. |
| Coastal or high-exposure architectural profile | Often 6063-T5 or 6063-T6; alloy and finish should be matched to the project specification. | Specify an appropriate anodic-film thickness, sealing, and maintenance plan for the exposure; anodizing does not make aluminum corrosion-proof. | Salt exposure, sheltered versus unsheltered location, water traps, dissimilar-metal contact, coating specification, and maintenance access. | Exterior frames, façade components, and other exposed building elements. |